User Manual

TRIGGER MECHANISM REMOVAL INSTRUCTIONS
Your "ZOLI" shotgun has the advantage that the trigger assembly is fully
removable and this assembly contains all the gunlock components except
the safety selector and the firing pins.
This unique characteristic of your shotgun allows easy repair and main
-
tenance thanks to the ease of disassembly and reassembly.
We recommend that you remove the trigger assembly only if it is abso
-
lutely necessary because the mechanism in question is very finely tuned.
If you do wish to remove the mechanism proceed as follows
WARNING
Before any maintenance ensure that the cartridge chambers are empty
and follow the "SAFETY INFORMATION" paragraph of the Instruction
Manual, relating to your shotgun.[Page 22]
TO DISASSEMBLE
1. Un-cock the hammers by acting as follows; with snap caps in the car
-
tridge chambers:
a) First pull the trigger once.
b) Engage the safety mechanism by moving the button (1 - Fig. 2) rear
-
ward towards the stock until it shows fully the "S" letter that is engraved
on the action-frame (a - Fig. 2); next take the gun off safe by moving the
button in the opposite direction (b - Fig. 2). This manoeuvre serves to
simulate the recoil of the shot.
c) Pull the trigger again.
2. Engage the safety mechanism again (a - Fig. 2).
3. By using a suitable 2.5mm hexagonal wrench (2 - Fig. 1) unscrew
completely the screw (1 - Fig. 1) that is located in the rear of the trigger
guard.
4. Take out the trigger assembly by pulling it from the rear side as sho
-
wed in figure 2 (ref. c). Operate with great caution.
5. Lay the trigger assembly in a clean place and preserve it with care
(dust grit or other foreign matter can seriously compromise the working
of the precision mechanisms).