User Manual

TO ASSEMBLE

1. Take the gun off safe by pushing forward the safety button on the

action frame (b - Fig. 2).

2. Make sure the hammers are un-cocked (3 - Fig. 1); the same position

as they are for disassembly.

3. Insert (a - Fig. 3) the trigger assembly positioning first the tenon (4 -

Fig. 1); afterwards rotate the assembly and press it until is seated cor

rectly (b - Fig. 3).

If you encounter resistance in seating the assembly, absolutely DO NOT

use excessive force, but repeat the manoeuvre with caution.

4. By using a suitable 2.5mm hexagonal wrench tighten the screw (1 -

Fig. 1) that is located in the rear of the trigger guard. Do not use exces

sive pressure to tighten.

5. Verify that the shotgun functions correctly by simulating two shots

with snap caps in the cartridge chambers. Operate to un-cock the ham

mers (point 1 of disassemble procedure).

SAFETY OPERATION

ATTENTION for the models

provided with manual cocking

systems, please refer the chapter

“for information about the manual

cocking mechanism”.[Page 31]

1. The safety mechanism on your

shotgun is located on the action tang immediately behind of the top lever

To engage the safety mechanism, place your thumb on the safety and

move it rearward towards the butt. When it is in the correct “safe” posi

tion, you will see the letter “S” fully exposed on the tang directly in front

of the top edge of the safety. When the letter “S” is fully exposed the

safety is “ON”.

To take the gun off safe, place your thumb on the safety and push it

forward until it covers the letter “S”. The shotgun is now ready to fire.

WARNING

REMEMBER that the safety mechanism is not a substitute for safe

gun handling. To avoid serious injury to you or others always keep

the gun pointed in a safe direction even when the safety is engaged.