Owner`s manual

OPERATION CONTINUED
CCO – This method requires the identication of the particular
battery size (capacity) and chemistry, an exclusive Anton/Bauer
Logic Series feature. The charger determines the maximum
charge time for the particular battery and uses this information to
ensure that overcharge conditions are avoided.
FUL – This determination is made when a fully charged DIGITAL
batteryisreturnedtothechargerwithinspeciedparametersand
immediately indicates a fully charged condition, without additional
verication.
TEMPERATURE COMPENSATED VCO – for NiMh series
ofbatteries. Similar to a VCO, however, only operates within
certain temperature parameters.
2. Stage Two charging is a BALANCING or “equalize” mode which
calculates each battery pack type to offset any imbalance of the
battery’s cells, created by unequal self discharge or any capacity
mismatch of the individual cells in the pack. This stage can vary in
duration from zero to as much as 16 hours, depending on the condition
of the battery. A battery will typically leave Stage Two in 2-4 hours
under average operating conditions.
3. Stage Three charging is the Anton/Bauer exclusive Lifesaver
maintenance mode. This patented pulse routine keeps batteries fully
charged, free from self-discharge – indenitely – without damaging
heat associated with so-called “trickle charge”.
LED INDICATIONS
LED INDICATION MEANING
Red and Green Alternating Indicates that the charger is evaluating
the battery and/or communicating,
battery, loading battery parameters and
determining the appropriate charge
routine. A low voltage (<11V) battery will
cause this indication to continue until
the battery is “rejuvenated” to a safe
charging voltage.
Steady Red Indicates that the battery is being held by
the charger to stabilize an out-of-range
temperature condition.
Flashing Red Indicates that the battery is currently
charging.
Steady Green
Indicates that the battery is READY for
use
FCC NOTICE
This equipment has been tested and found to comply with the limits for a
Class A digital device pursuant to Part 15 f the FCC rules. These limits are
designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency and, if
not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his
own expense.
This equipment has been approved by one or more agencies. All
changes and/or modications not expressly approved by Anton
Bauer, Inc. could void the users’ warranty and authority to operate this
equipment. There are not serviceable parts in this equipment.
SPECIFICATIONS
Dimensions: 10 ¼ x 2 ¼ x 8 ½
Weight: 4.2 lbs
Input Voltage: 100-240 VAC, 50-60 Hz
2
Approved Copy