APPROVED COPY ® ™ TITAN 70 Charger / Power Supply OWNER’S MANUAL
APPROVED COPY
APPROVED COPY TABLE OF CONTENTS INTRODUCTION .......................................................................................... 1 FEATURES .................................................................................................... 1 SAFEGUARDS.............................................................................................. 2 GROUNDING/EARTHING........................................................................... 2 Charging ................................................
APPROVED COPY INTRODUCTION The TITAN™ 70 is the smallest and lightest package available in both a charger and on-camera power supply. It incorporates all of the Logic Series® circuits that are employed in every Anton/Bauer® charger. The fast charge feature makes it an ideal complement to a current Anton/Bauer battery system and given its small size is ideal for travel. Like all Anton/Bauer chargers, everything is automatic.
APPROVED COPY SAFEGUARDS Power Sources: This unit was designed to operate at mains voltages from 90 to 250 Volts AC, 50-60 Hz. Risk of Electrical Shock: Refer servicing to qualified service personnel. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. GROUNDING/EARTHING IMPORTANT WARNING: THIS APPARATUS MUST BE EARTHED.
APPROVED COPY Charging As with all Anton/Bauer chargers, charging with TITAN 70 is fully automatic. Mount any Logic Series battery to the TITAN 70 and it will automatically determine and execute the appropriate charge routine. Applications The Titan 70 will charge any Anton/Bauer Logic Series Gold Mount® battery including model: ProPac® 13/14, Trimpac® 13/14, Digital ProPac 13/14, Digital Trimpac 13/14, HyTRON, or ProFormer® battery.
APPROVED COPY Three Stage Charging Methodology In general, the TITAN 70 will deliver a three stage charge routine to each battery. 1. Stage One will deliver a high rate charge matched to the capabilities of the battery (typically a one or two hour rate, depending on battery type).
APPROVED COPY LED Indications The TITAN 70 has three LEDs (one red, two green). One green LED indicates AC line voltage status. If the green status LED is steady, then line voltage is present. If the green status LED is flashing, then AC Line voltage has been removed. The red and green LED’s will indicate the charging status of the battery.
APPROVED COPY OPERATION AS DC CAMERA SUPPLY FROM MAINS The TITAN 70 will automatically operate as a DC power supply once the camera, or other device is turned on. There are no switches, it is fully automatic. The single green LED will light indicating that the unit is operating as a power supply. A battery may be attached to TITAN 70 while mounted to a camera. With the camera OFF, the battery will charge.
APPROVED COPY FCC NOTICE This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
APPROVED COPY LIMITED WARRANTY This one (1) year limited warranty for the product specified in this document is given by Anton/Bauer, Inc. (“Anton/Bauer”), 14 Progress Drive, Shelton, Connecticut 06484. If you have any questions regarding product applications, product specification, or to obtain warranty service on this or any Anton/Bauer product, contact the Anton/Bauer Customer Support Group or the company at the address above.
