Datasheet

ManualsBrandsAntistat ManualsActive ComponentsESD mat Grey (L x W x H) 900 x 600 x 2 mm

0820034F  SMOOTH ANTISTATIC MAT  2 LAYER | 2 NOVEMBER 2023 12:51 PM V1

To request a quotation or for more information, please call +44 (0)1473 836200

email info@antistat.co.uk or visit www.antistat.co.uk

IMPORTANT: This data sheet and its contents (the “Information”) belong to Antistat or are licensed to it. No licence is granted for the use of it other than for information purposes in connection with the products to which it

relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but

Antistat assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the

products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from

Smooth Antistatic Mat - 2 Layer

TECHNICAL DATASHEET

Antistatic matting can be laid out in the workshops or

advanced laboratories for microelectronic industries

such as electronic semiconductor devices, electronic

computers, electronic communication equipment and

integrated circuits etc.

∙ Great value ESD Bench Matting

∙ Made from antistatic (conductive) and static-dissipative

materials with synthetic rubber

∙ 2mm thick double-layer structure

∙ Surface layer is a 0.5mm thick static-dissipative layer

∙ Bottom layer is a 1.5mm conductive layer

∙ Available in grey

∙ Includes one stud in each corner as standard

PRODUCT

FEATURES

COLOURS

GREY

PRODUCT CODE DESCRIPTION SIZE MM COLOUR

082-0034F ESD Bench Matting - 2 Layer, Smooth Finish 600 x 1200mm Grey

082-0034F3 ESD Bench Matting - 2 Layer, Smooth Finish 600 x 900mm Grey

Summary of content (3 pages)

PAGE 1
PRODUCT Smooth Antistatic Mat - 2 Layer TECHNICAL DATASHEET Antistatic matting can be laid out in the workshops or advanced laboratories for microelectronic industries such as electronic semiconductor devices, electronic computers, electronic communication equipment and integrated circuits etc. COLOURS GREY FEATURES ∙ Great value ESD Bench Matting ∙ Made from antistatic (conductive) and static-dissipative materials with synthetic rubber ∙ 2mm thick double-layer structure ∙ Surface layer is a 0.
PAGE 2
Grounding Sufficient ground cords should be used to reliably meet EN 61340-5-1 Table 3: less than 1 x 109 ohms for working surfaces. Industry recommendation is that continuous runs of ESD matting should be grounded at 10ft intervals to allow proper charge decay rates. Each individual ESD mat should be grounded with ground snaps located no further than five feet from either end.
PAGE 3
TEST RESULTS TEST METHOD UNIT VALUE Surface Resistance / RtG SJ/T10694-2004 Ohms 1x106 ≤ R ≤ 1x109 Bottom Resistance / RTT SJ/T10694-2004 Ohms 1x103 ≤ R ≤ 1x106 Volume Resistance GB/T14437-97 Ohms 1x105 ≤ R ≤ 1x108 Thickness YY-1001 mm Permissable Tolerance +0.