Datasheet
0820028F ESD BENCH MATTING 2 LAYER SMOOTH FINISH | 12 JANUARY 2023 1:41 PM V1
To request a quotation or for more information, please call +44 (0)1473 836200
email info@antistat.co.uk or visit www.antistat.co.uk
IMPORTANT: This data sheet and its contents (the “Information”) belong to Antistat or are licensed to it. No licence is granted for the use of it other than for information purposes in connection with the products to which it
relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but
Antistat assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the
products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from
negligence or where Antistat was aware of the possibility of such loss or damage arising) is excluded. © 2023 Antistat.
TEST RESULTS
TEST METHOD UNIT VALUE
Surface Resistance / R
SJ/T10694-2004 Ohms 1x10 ≤ R ≤ 1x10
Bottom Resistance / R
SJ/T10694-2004 Ohms 1x10 ≤ R ≤ 1x10
Volume Resistance GB/T14437-97 Ohms 1x10 ≤ R ≤ 1x10
Thickness YY-1001 mm Permissable Tolerance +0.1
Temperature Resistance YY-1001 ºC 180 (Instantaneous Temp)
Temperature N/A ºC 20-26
Relative Humidity N/A % 40-65
R
is the resistance from one point on the mat’s surface to the mat’s ground point, and is the
fundamental electrical test for a mat. A proper R
insures that a mat can conduct charge from a
point on the surface to the mat ground point. The guideline in ESD STM-4.1 for RTG is 1x10 to 1x10
Ohms. ANSI/ESD S-20.20 has an upper limit of <1 x10 Ohms.
R
is the resistance from one point on the mat’s surface to another point. A proper R
insures the
consistency of the mat’s resistance properties. The ESD STM-4.1 guideline for R
is >1x10 Ohms.