Datasheet

0180001  UK  MOISTURE BARRIER BAG  3.6MIL V3 | 1 SEPTEMBER 2023 10:51 AM V1
To request a quotation or for more information, please call [phone]
email [e-mail] or visit www.antistat.co.uk
IMPORTANT: This data sheet and its contents (the “Information”) belong to Antistat or are licensed to it. No licence is granted for the use of it other than for information purposes in connection with the products to which it
relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but
Antistat assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the
products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from
negligence or where Antistat was aware of the possibility of such loss or damage arising) is excluded. © 2021 Antistat.
ITEM TEST METHOD TYPICAL VALUE
Film Composition N/A PET/AL/NY/PE
Inner and Outer Resistance STM.11.11 10 - 10 Ohms
Moisture Vapour Transmission Rate ASTM F 1249 <=0.035g/100sq/in / 24 hours
Tensile Strength ASTM D882 7500 PSI
Puncture Resistance ASTM F1306-90(2002) 24lbs
Heat Seal Temperature - 300-410°F
Heat Seal Time - 0.5-3.5 sec
Heat Seal Pressure - 30-70 PSI
Seal Strength GB/96-04-10 12lbs
Static Decay Time IEC61340-5-1 (±1000 - ±100V) ≤2S
TEST CONDITIONS
The following results were taken under the following environmental test conditions:
Temperature: 23C / Humidity: 12%
TEST CONDITIONS
The anti-static moisture barrier bag is tested accordant with the relevant test standard and requirements.
Test Item: Test Method: Measured Equipment(s): MDL:
Lead (Pb) IEC 62321:2008 Ed.1 Sec.8 ICP-OES 2mg/kg
Cadmium (Cd) IEC 62321:2008 Ed.1 Sec.8 ICP-OES 2mg/kg
Mercury (Hg) IEC 62321:2008 Ed.1 Sec.7 ICP-OES 2mg/kg
Hexavalent Chromium (Cr(VI)) IEC 62321:2008 Ed.1 Annex C UV-Vis 2mg/kg
Polybrominated Biphenyls (PBBs) IEC 62321:2008 Ed.1 Annex A GC-MS 5mg/kg
Polybrominated Diphenyl Ethers (PBDEs) IEC 62321:2008 Ed.1 Annex A GC-MS 5mg/kg
EMI Shielding: Meets required range of EN 61340-5-1 tested per IEC 61340-2-3 and ANSI/ESD STM11.31