Specifications

EN 5008 8-in-1 MPEG-4 AVC/H.264 HD User’s Manual
27 / 43
Antik Technology / www.antiktech.com
Users can click Equipment Name on the node tree and enter in the Parameter interface by
clicking and or to configure the parameters.
4.3.1.1 General Parameters
Set: to make the current parameters shown in the SNMP software activate.
Get: to read the current device’s activating parameters and show them on SNMP software.
 IP Out Enable
Check the checkbox with “√”, then the IP output is enabled, otherwise it is not. Users can
decide whether to open the IP output function or not.Users can modify the IP address here as
well.
 IP Out Address/Service IP Address/Service Mask/Service Gateway
Users can set the address by modifying the value in these four fields.
 ASI Output Channel
Users can check version
information in this area.