User's Manual

2020.04.14
TP, rev1
Side 3 af 4
- Consult the dealer or an experienced radio/TV technician for help.
Instructions
Only Anticimex service technicians are allowed to install, replace damaged units, and service
installations. Replace the Smart Clima if the device is faulty.
To install the Smart Clima system the operator must possess a mobile device such as a smartphone
or tablet with access to an internet connection. To install, the operator should have a user in the
Anticimex-owned software system “Smart Device Tool”.
1. Use Smart Device Tool to initiate an installation
2. Select or create customer and site
3. Add installation
4. Scan the QR-code of the Smart Connect Mini
5. Apply power to the Smart Connect Mini and await green flashes of the gateway, indicating
beacon mode is active: You can now start to set up the sensors
a. Start setting up Smart Climas closest to the gateway
6. Push the button of the sensor until green LED have flashed 3 times (app. 4 seconds) and
await green flashes every 10 seconds, indicating connection.
7. Continue to set up all the Smart Climas of the installation in the same way
8. When all sensors have been installed, end the installation through Smart Device Tool
a. During this step, the installation will form its mesh and pair the Smart Clima devices.
9. If the connection has formed without any problems, the installation is complete
10. If there are problems, investigate using Smart Device Tool which Smart Clima(s) did not
connect: Either relocate them or adjust the installation by adding an extra Smart Clima to
solve the problem
11. End installation through Smart Device Tool.
12. Remember to leave Service Mode.