Integration Guide

3/15
29.10.2019
Anticimex Innovation Center A/S
Skovgaardsvej 25
3200 Helsinge, Denmark
Phone [phone], [e-mail]
anticimex.com/innovationcenter
Reg no. DK30350766
Registered office:
Helsinge
References
[1] CC1312R SimpleLink™ High-Performance Sub-1 GHz Wireless MCU, Technical datasheet
COPA Mesh module overview
The COPA mesh module consists of a sub-GHz wireless MCU (CC1312R from TI), a PCB
antenna, a Lithium-type battery, memory, PIR sensor, power circuitry, temperature sensor,
LEDs and several different GPIOs to interface with the outside world.
A COPA Mesh board can be used in a gateway or as a stand-alone board in a sensor device
handling sensor data communication within a mesh network. Sensors could include; PIR
devices and rodent traps.
Compliance statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
(47 CFR 15.19)
Caution: any changes or modifications not expressly approved by Anticimex Innovation
Center A/S will void the user’s authority to operate the equipment (47 CFR 15.21)
The antenna is fixed to the device and no change in antenna or fixation of the antenna is
acceptable and such modification is considered to violate the Compliance Statement.
The Cope Mesh module is in compliance with the requirement for RF exposure in US with 20
cm separation distance between the user and/or bystander of the device.
As per 47 CFR 15.105 this equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures: