Operating instructions

35
3. SETUP continued …
EQ (MAIN only):
For sources set to Digital or Anlg-DSP, you can preset low and high frequency levels. This is useful for source
components that have frequency irregularities. After highlighting the EQ line, press SELECT and use the
34 buttons to select LF (low frequency) or HF (high frequency), then use the 56 buttons to adjust. In the
FM/AM Setup/Presets menu, FM and AM can be adjusted separately. The EQ settings in this menu and the
on-the-fly BASS / TREBLE adjustments do not
affect each other (see section 4.7).
Bass Manager (MAIN only):
Choose between Movie or Music configuration as set in the Bass Management menu, or Auto-LFE. When
Auto-LFE is selected, the Movie configuration is used if the source contains LFE, and changes to the Music
configuration at all other times. Auto-LFE is recommended when using two bass management configurations
and the same player for DVDs and CDs.
Room EQ (MAIN only):
To disable room correction equalization performed with the ARC-1 microphone kit, change this to Off. If
measurement info isn’t loaded “NA” is displayed.
Lip-Sync (MAIN only):
Video can become unsynchronized with audio for different reasons. The Statement D2v’s video processing
is considered to be synchronized with the audio because it only causes a 24 millisecond delay, which is less
than the duration of one frame. If audio is heard before its corresponding image is seen, you can set up to
170 milliseconds of audio delay. To adjust while watching the image see section 4.9.
Example: Set DVD1 Lip-Sync delay to 24 milliseconds.
• Enter the setup menu. Go to SOURCE SETUP and press SELECT.
• Press the 6 button until you reach DVD1 and press SELECT.
• Press the 6 button until you reach LIP-SYNC and press SELECT.
• Use the 34 buttons to move from digit to digit and the 56 buttons to adjust to 24 ms.
• Press BACK to leave the submenu and return to the main menu.