Owner manual

4.8.10 DYNAMICS

This allows you to control the difference between the softest and loudest passages on 5.1/6.1-channel

soundtracks, as long as the soundtrack contains dynamic scaling information and at least 5.1 speakers are

used. Press DYNAMICS and then use the Master Control Knob or  keys on the remote control to select:

Reduced: Allows the quieter parts to be heard more easily, and works by raising the level of quieter

sounds and/or reducing the level of louder ones according to cues encoded on the DVD.

Late Night: Reduces the softest-to-loudest difference even further.

‘Reduced’ and ‘Late Night’ get reset back to ‘Normal’ when Main power is turned off.

4.9 LIP-SYNC DELAY (Remote Control Only)

To adjust Lip-Sync Delay while viewing the picture and listening to the soundtrack simultaneously,

press and hold the DISPLAY key until the display shows “LIP-SYNC DELAY”, then use the  keys

to move from digit to digit and the  keys to adjust (see section 3.5).

4.10 DISPLAY BRIGHTNESS (Front Panel Only)

The brightness of the Front Panel display and LED indicators can be changed. Press

DISPLAY and then use the Master Control Knob to select Maximum, High, Medium, Low,

or Off. The Front Panel Wake-Up can be modified, as can the time-to-rest when the

display will dim (see section 3.10).

4.11 SLEEP TIMER (Remote Control Only)

If you would like to go sleep while listening to a program or music, the Sleep Timer will automatically

turn the AVM 30 power off after a preselected time. So when you find yourself falling asleep at the

TV, take the Remote Control and:

• Select the desired Path (MAIN, ZONE2, or ZONE3), then press SLEEP (the Sleep timer will operate

for that Path only).

• The first SLEEP keystroke always resets the timer to 30 minutes. Additional keystrokes then cycle

as follows: Second=60, third=90, fourth=Disabled.

• Once set, the time remaining appears as the number following ‘Zzz’ in the display.

4.12 ENABLE / DISABLE TIMERS (Remote Control Only)

To enable or disable all timers without entering the Setup, press and hold the SLEEP key until the display

shows ‘ALL TIMERS’, then use the  keys to enable/disable (see section 3.1).

4. OPERATION continued …

SLEEP