Specifications

INSERTION OF THE TUBES
1. Using the screwdriver supplied, remove the cover of
the Integrated 1. For your convenience, only two of the
screws are installed at the factory.
2. When handling the tubes, it is recommended that the
cotton gloves provided be worn to prevent skin oils from
depositing on the glass surface and possibly causing the
tube to become prematurely “gassy”, thereby shortening
the tube’s useful operating life.
3. Noting the location of the tube sockets in the top view
photo, inspect the tubes for corresponding labels and
markings. Once locations are mapped, take a tube and
inspect the pins, noting the larger space between two of
the pins (see Figure 3). This space will match with the
socket. Insert each tube into the appropriate tube sock-
et, making sure all pins and pin holes are aligned. Do not
force the tubes into the sockets. “Rock” the tubes gently
while pushing slowly until each tube is firmly seated.
O P E R A T I O N
Before plugging in the Integrated 1, check to see that the
unit is configured for the correct AC line voltage for coun-
try of use. The operating AC line voltage is indicated on
the side of the shipping box. If the Integrated 1 is set
incorrectly for the country in which it is to be operated,
contact the dealer or distributor in your area. If the unit is
configured properly, continue with operation.
Connect the Detachable Power Cord to the Integrated 1
AC Power Cord Socket (H) (see Figure 4). Plug your
Integrated 1 into the AC power source.
All remaining connections are made with co-axial cable
and RCA connectors to or from other single-ended units.
Connect source units to the Integrated 1 Inputs (L); l e f t
channel to left channel and right channel to right channel.
If a tape or other line level recording or processing device
is being implemented, connect the left and right audio out-
put of the unit to the corresponding left and right Tape/
EPL Input (N) of the Integrated 1. Also connect the left and
right Tape/EPL Outputs (K) on the Integrated 1 to the cor-
responding left and right audio inputs of the external
device.
Connect loudspeakers to the appropriate post as
described in the connection section of this manual.
The Integrated 1 is now ready for operation. Power the
Integrated 1 by placing the On-Off button (G) in the ON
position. The tubes will take approximately 30 seconds to
warm up and then the Integrated 1 is functional.
Select a ready source through the Selector Switch (A).
Balance is adjusted through use of the Balance Control (B);
turning it left and right will adjust the left and right levels
respectively in a -6dB adjustment range. The center detent
is an indicator for equal, or balanced, left and right levels.
Volume is adjusted through use of the Volume Control (C).
Turning this control clockwise increases the volume level
of both channels. Be sure the level is sufficiently low when
turning the unit ON or returning to the OPERATE mode
after MUTING, to prevent damage to speakers, amplifiers
Note the larger space
between two of the pins and
holes for proper alignment
of tube and socket.
FIGU RE 3