Specifications

A SELECTOR SWITCH
This knob is rotated to select a Line Level Input (L) or
the optional Phono Input (O). The Selector Switch is
bypassed when the Tape/EPL (External Processor
Loop) mode is selected by depressing the Ta p e / E P L -
Source button (D).
B BALANCE CONTROL
This knob controls the relative balance of the left and
right channels to compensate for any discrepancies
caused by speaker placement, source imbalance, etc.
Full rotation to the left or right of the center detent will
have a ±6dB trim on levels between left and right
channels.
C VOLUME CONTROL
This knob allows variable control over the Integrated 1
output level. Turn it clockwise and the music gets louder!
D TAPE/EPL(EXTERNAL PROCESSOR LOOP)-
SOURCE BUTTON
When this button is in the SOURCE position (button is
not depressed) the signal is routed through the
Selector Switch (A) to the Tape/EPL Output (K) con-
nected with a tape deck or external processor such as
a surround sound decoder. Listening and taping is
done in this mode. When the button is depressed, the
source signal is taken from a tape or processor source
through the Tape/EPL Inputs (N) bypassing the selec-
tor switch.
E L E D
When the LED is lighted the Integrated 1 is “ON”,
receiving power from the power supply.
F M U T E - O P E R ATE BUTTON
When in the OPERATE position (not depressed), this
button will allow normal function. When in the MUTE
position (button depressed), the music signal is cut off
from reaching the Outputs (I,J,).
G ON-OFF BUTTON
When in the ON position (button depressed), high volt-
age power is received by the Integrated 1 circuitry
from the power source. Due to the warm up charac-
teristics of tubes, it will take 30 seconds for the tubes
to pass full signal. It is suggested that the Integrated 1
remain muted or the Volume turned down for this first
minute. When in the OFF position (not depressed), the
Integrated 1 is not receiving power and is not opera-
tional.
C O N T R O L F U N C T I O N S