Specifications

or the Integrated 1.
To record from a source, place the Tape/EPL-Source but-
ton (D) in the SOURCE position, select the source material
you wish to record via the Selector Switch (A), and com-
mence recording. To play back a tape recording, place the
Tape EPL/ Source button in the TAPE position.
Muting the Integrated 1 is achieved by placing the
Mute/Operate button (G) in the MUTE position (button
depressed); the output signal is then cut off. To resume
listening, place the button in the OPERATE position (not
depressed).
T R O U B L E S H O O T I N G
If at any time the Integrated 1 fails to work properly, consult
this checklist:
1. Check that the AC Detachable Power Cord is plugged into
the Integrated 1 Detachable Power Cord Socket (H) and is
connected to a live source of AC power. For instance, if using
a power bar, check that the bar is turned on.
2. Ensure that all Input and Output connections are secure for
a proper electrical contact.
3. DISCONNECT THE AC POWER CORD, wait 5 minutes,
remove the chassis covers from the Integrated 1 and Power
Supply and check that:
• A slo-blo fuse, with a rating of 2.5 Amp/250 V (1.25
Amp/250 V for European and Asian versions), is installed in
the cylindrical tube next to the large power transformer.
• The AC power fuse is intact and has not blown. If the fuse
has blown, the thin metal conductor will have melted and the
glass may appear “smoked”. If the fuse has blown, replace
with a fuse of the same rating (2.5 Amp/250V slo-blo for 100
to 120 volt countries and 1.25 Amp/250V slo-blo for 200 to
240 volt countries). (See Figure 5)
NOTE: Under no circumstances should you replace the AC
power fuse with one of a higher current rating! Doing so may
cause further damage to the Integrated 1 and will also void
the warranty. In addition, your continued protection from risk
of fire or shock would be seriously compromised.
• Ensure the tubes are plugged firmly into their sockets as
described in “INSERTION OF THE TUBES”.
5. Be sure the rest of the system is functioning properly (i.e.
source unit, power amplifiers, cables and connections, etc.).
6. With tubes, fuses, covers and power cords in place, check
that the LED (E) is lighted (glowing light green). If all of the
above troubleshooting steps have been followed and the LED
is not lighted (remains dark green), contact your dealer or
distributor for assistance.
FIGURE 5
Fuse location in the Power Supply and removal.
WARNING-DISCONNECT THE A C D E TA C H -
A B L E P O W E R C O R DF R O M T H EI N T E G -
R ATED 1 AND WAIT 5 MINUTES BEFORE
REMOVING COVER, TUBES OR FUSE.
FIG URE 4
Alignment of the AC power connector and detachable cord.