Music Mixer User Manual

3.14 LOCKOUT / PASSWORDS

Passwords are used to protect the saved User and Installer settings. Once you have set a password, it can

also be used as a Lockout to prevent settings from being changed by anyone without one of the passwords.

Lock Settings:

When set to Yes, entry to the setup menu is prevented unless the password is entered first.

Set User or Installer Password:

Whether or not settings are locked, if a password is set, it will still be required to save changes to User or

Installer settings. Pick a 4-digit number that you will remember easily. To enter it, use the 0 – 9 keys on the

remote control (password cannot be entered from the front panel). To change a password, enter the old one,

then enter (and confirm) the new one. Keep a record of your password in case it’s forgotten!

Example 1: Set User Password (remote control only).

• Enter the setup menu. You must enter the USER or INSTALLER password if there is one.

• Go to LOCKOUT/PASSWORDS and press SELECT.

• Press the  key to go to SET USER PASSWORD.

• Press SELECT. You will be asked to enter a four digit number – use the 0 – 9 keys. If you are

changing your password you will be asked to enter your old one first. You will also be asked to

confirm your new one.

Clearing the password: When asked for your new password, press the  key four times. You will also

be asked to confirm – press the  key four times again. Message will say “User Password Removed”.

Example 2: Lock Settings (remote control only).

• Enter the setup menu. Go to LOCKOUT/PASSWORDS and press SELECT.

• Upon entering this menu item, LOCK SETTINGS will be highlighted in red.

• Press SELECT. You will be asked to enter a password. The USER or INSTALLER password will work.

• Use the  buttons to change to Yes or No.

• Press SELECT or BACK.

3. SETUP continued …

14. LOCKOUT / PASSWORDS

a. LOCK SETTINGS

b. SET USER PASSWORD

c. SET INSTALLER PASSW'D