Installation guide

Last revision. 12/00
4
3
2.2 Starting the Playback
Now with the SPC file loaded and it displayed in the waveform display area, click on the
PLAY button located in the Record and Playback Transport.
Please take note of the horizontal red line(s) progressing from left to right as the SPC file is
played back. This shows the progress of the playback of the SPC file.
To STOP the playback at any time use the mouse to click on the STOP button.
If you wish to listen to a different SPC file that has been previously recorded, just click on the
CLEAR button in the File Load and Clear Transport, then click on LOAD to
enter a new five-digit SPC file name/number.
2.3 Monitoring the Playback of an SPC File
To the right of the Playback Transport is the Monitor or Audio Monitor & Waveform
Amplitude Controls. These functions allow monitoring while recording or editing an SPC
file. It also provides for increasing or decreasing the SPC waveform size for visual clarity.
The MONITOR button will activate and deactivate audio capability of the
RF Edit program. In the event you are on the air you may still hear the actual broadcast in the
background.
The
‘+’ button increases waveform amplitude size in the waveform display window and
the ‘-‘ button decreases waveform amplitude size in the waveform display window.
To increase the waveform amplitude click on the ‘+’ button. The amplitude size increases
and clarity of the display will become bigger.
To decrease the waveform amplitude click on the ‘-‘ button. The amplitude size decreases
and clarity of the display will become smaller.