Installation guide

Last revision. 12/00
4
2
1.3 Starting a New Recording
To START recording a new SPC file have your audio source ready to go and in standby and
then just click on the
RECORD button. Now start the audio source that is being used.
While the recording is in progress Player #4 will display movement in the VU meters.
To STOP the recording just click on the STOP button.
RF Edit automatically saves the SPC file you are recording so there is no need to click on a
“save” button (that’s why there isn’t one). The SPC file is saved to C:\SPC by default.
After the recording has been stopped to display the SPC waveform in the Waveform Display
Window click on the LOAD button.
1.4 Appending to a Recording
To APPEND or add to the end of existing audio file, have your audio source ready to go and
in standby. There is no need to mark the end of the file, APPEND will automatically
start recording at the end of the file you are working with.
Next click on the APPEND button and start your audio source.
To STOP the recording just click on the STOP button.
You may need to edit some dead air space where this file picked up recording. Just refer to
the section “Editing an SPC File” in this reference guide.
After the recording has been stopped to display the SPC waveform in the Waveform Display
Window click on the LOAD button.
2. Playing Back a SPC File:
2.1 Entering a Five Digit SPC File Name/Number
Just like when we recorded a new SPC file, we load the SPC file name/number via the file
load transport in the RF Edit program.
Again using your mouse click on the numbers (
, , , , etc. …) just to the left of the
LOAD and CLEAR transport buttons.
When you have finished clicking in the number, just click on the LOAD button.
The SPC file you have chosen will be displayed in the Audio File name area and
the waveform will be displayed in the waveform display window.