Installation guide

Last revision. 12/00
4
0
Waveform Display: Located in the center of the RF Edit
display is the waveform display window. It is the largest window in the RF Edit display area and is
used to view the actual waveform of the SPC file you are working with.
Shortcuts: Located at the left uppermost corner of the RF Edit display are the shortcuts for
jumping to the BEGINNING, MIDDLE, or END of an SPC file displayed in the Waveform Display
Window. The audio cursor (displayed as a vertical red bar in the SPC waveform) will be placed in
the approximate begin, middle, or end of the waveform.
Block & Trim Transport: Located at the lower leftmost of the RF Edit display
area is the Block & Trim Transport. The Block & Trim Transport is used for marking the
BEGinning and ENDing of a waveform area of an SPC file displayed in the Waveform Display
Window.
Trims audio from the beginning of the audio file to the begin marker.
Trims audio from the end of the audio file to the end marker.
Waveform Scroll & Block Edit Controls:
Located at the lower part of the RF Edit display area and just to the right of the Block & Trim
Transport is the Waveform Scroll & Block Edit Controls. These controls are used for scrolling
through an SPC waveform, playing a marked block in the SPC waveform, and editing the actual SPC
waveform itself.
- “Clears” all audio block markers.
- “Plays” audio within the block markers.
- “Deletes” audio within the block markers.
- “Copies” audio within the block markers.
Record & Playback Transport:
Located at the lower part of the RF Edit display area and to the right of the Waveform Scroll &
Block Edit Controls is the Record & Playback Transport. These controls are used for the recording,
playback, and appending SPC files. Also displayed is the audio compression type used, the sample
rate and EXIT of the RF Edit utility.