Installation guide

Last revision. 12/00
3
9
File Load & Clear Transport
Audio File Located in the upper left of this status area, “Audio File” displays the five-
digit SPC file being recorded or edited in the waveform display window.
Position:Located just under Audio File, “Position” shows the exact position of the audio
cursor in numeric form from the waveform display window. The audio cursor is the tall, red, vertical
bar within the waveform display area.
Block Time: Located just to the right of Audio File is the Block Time status box.
Block Time is the amount of time within a ‘blocked’ section of the displayed file in the waveform
display area. A block has a BEGIN and an END marker. Block time is the time contained within the
BEGIN and END marked block.
Total Time Located just under Block Time is the Total Time status box. Total Time
refers to the total time that the SPC file in the waveform display area takes to play. This includes any
BEGINing or ENDing area that has nothing recorded in it (i.e. dead air).
File Load & Clear Transport Located at the lower right most corner of the
RF Edit display is the File Load & Clear Transport. This area is used for entering the five-digit SPC
filename/number of the new SPC file you wish to create or the SPC file you wish to edit.
B
efore you do recording or
e
diting of any kind an SPC file
n
ame/number must be in use or
e
ntered.