Installation guide

Last revision. 12/00
2
8
The Sage features three programmable relays:
1. Attention Active
2. Encoder Active
3. Decoder Active
The Sage Endec Connections to the Metrabyte Setup are as follows:
Decoder Active & Attention Active or Encoder Active should be connected to Pin 37 on the STA-U
(Blue Box)
Note
: Depending on which ones are programmed for EAS Alert and End of Message tones, the two
should be connected to Pin 37. Default Setup has Decoder Active set to EAS Alert, so you would only
have to program one of the other relays. These relays contain+5 volts.
Manual Override should be connected to Relay 23 on the ERB-24 (Relay Board).
Note
: A +5 volt needs to be connected to the manual override relay and then back to any ground through
Relay 23 on the ERB-24 to complete the loop.