Installation guide

Last revision 12/00 8
II. Software Installation
Step 1: DOS Setup
Make sure that DOS is installed and that the system is correctly booting off the first hard drive.
If DOS is not on the computer system, then it must be installed. To install DOS, consult your
MS-DOS user’s guide
.
Step 2: Software Installation
Place the first diskette labeled Pristine RapidFire into Drive A: Then type in the following:
A:RF-SETUP
(Enter)
Then follow the on-screen instructions to finish the installation.
After the files have been installed from the diskettes, the
autoexec.bat
must be edited to
include the following commands:
CD \RAPID
CALL PLAY
The following is what a typical RapidFire
config.sys
should look like:
DEVICE=C:\DOS\HIMEM.SYS
DEVICE=C:\DOS\EMM386.EXE NOEMS
DOS=HIGH,UMB
FILES=60
BUFFERS=30
LASTDRIVE=Z
DEVICEHIGH=C:\LANTASTI\PROTMAN.DOS /I:C:\LANTASTI
DEVICEHIGH=C:\LANTASTI\EL90X.DOS
The following is an example of what a typical RapidFire
autoexec.bat
should look like:
@ECHO OFF
PROMPT $p$g
PATH C:\;C:\DOS;C:\LANTASTI;C:\CTRL;C:\RAPID
SET TEMP=C:\TEMP
LH C:\DOS\SMARTDRV.EXE 2048 /X
CALL C:\LANTASTI\STARTNET.BAT
CD \RAPID
CALL PLAY