User Manual

Discrete 8 Pro Synergy Core User Manual
Page 60
Here are some additional tips regarding the cabinet modules:
● Change the cabinet model anytime from the ‘Cabinet’ drop-down menu.
● Change your cabinet’s mics from the ‘Mic A’ and ‘Mic B’ drop-down menus. Click
the adjacent ‘Phase’ button if your choice of microphones results in phasing
issues.
● Click and drag the virtual microphones to adjust their vertical and horizontal
positioning.
● Click and turn the ‘Mic A’ and ‘Mic B’ knobs to dial-in the amount of signal you
want from each microphone.
● Click and turn the ‘Rear Mic’ knob to mix-in signal from an additional mic behind
the cabinet.
● Click and turn the ‘45-degree Mic’ knob to mix-in signal from an additional mic
positioned at a 45-degree angle from a speaker cone.
● Click the ‘ReSPiRe’ button to hear some cab sim mojo courtesy of our friends
from Overloud.
In their own words, the ReSPiRe technology lets you switch
between the ‘real’ response of the cabinet and a processed version optimized to
fit into a mix and avoid frequency overlap with the other instruments.
● Click the ‘HPF’ button to engage a preset high-pass filter (tames excessive low
end).
● Click the ‘LPF’ button to engage a preset low-pass filter (tames harsh or shrill-
sounding highs).
● Click the ‘BP’ button to bypass the cab sim.
Finally, route the AFX OUT channels to COMP REC or in the DAW section to the Record
channel strips so you can record.
Software Re-amping