User Manual

9
6. AC power connection
This IEC connection supports inputs of 100 – 240 V~. This enables the device to
automatically accommodate mains voltages in any country.
7. WC Input
BNC Connector used to accept World Clock reference.
8. Atomic Clock Outputs
BNC Outlets for the 10MHz atomic clock signal. For best results cables should not
exceed 6 meters (20 feet) in length. Longer cables might work but will result in increased
jitter and other clock errors.
9. WC Outputs
The sample rate on these outputs always matches the sample rate shown on the front
panel frequency display.
10. S/PDIF Outputs
These two outputs provide S/PDIF clocking reference up to 192 kHz.
11. AES/EBU Outputs
These two outputs provide AES/EBU clocking reference up to 192kHz.
12. USB Connection
Allows connection to PC and MAC for complete remote control and rmware updates
thru the software control panel. The control panel for PC and MAC is available as a
download from the support section at www.antelopeaudio.com
5. Rear Panel Explained