User`s manual

The power supply is also equipped with a 3-pin fan signal connector. Connect it to one of the fan
connectors on your motherboard. You may monitor the speed of the rear power supply fan
through your motherboard BIOS or through the monitoring software that’s supplied with your
motherboard. Note: At low temperatures, the fan may run as slow as 950 RPM. At these speeds,
some motherboards may not properly detect the fan speed and may generate false warnings of fan
failure. To ensure proper monitoring of the fan, please check your motherboard manual.
CONNECTING THE USB PORTS
You will find a single 10-pin connector on a cable attached to the front USB ports. This is an
Intel standard connector, which is keyed so that it can’t be accidentally, reversed as long as it is
connected to a proper Intel standard motherboard header. Connect the 10-pin connector to your
motherboard headers so that the blocked pin fits over the missing header pin.
Note: Please check your motherboard manual for your USB header pin layout and make sure it
matches the attached table. If it does not match this Intel standard, please call Antec Customer
Support at (800) 22ANTEC (North America) or [phone] (Europe) for a USB adapter.
This adapter will allow you to connect the front USB to your motherboard on a pin-by-pin basis.
CONNECTING THE IEEE 1394 (FIREWIRE®, I.LINK®) PORT
You will find a single 10-pin connector on a cable attached to the front IEEE 1394 connection.
This is an Intel standard connector, which is keyed so that it can’t be accidentally reversed as long
as it is connected to a proper Intel standard motherboard header. Connect the 10-pin connector
to your motherboard header so that the blocked pin fits over the missing header pin.
Note: Please check your motherboard manual for your IEEE 1394 header pin layout and make
sure it matches the attached table. If you intend to connect the front FireWire port to an IEEE
1394 add-on card that comes with an external-type IEEE 1394 connector, please call Antec Customer
Support at (800) 22ANTEC (North America) or [phone] (Europe) for an adapter.
This adapter will allow you to connect the front IEEE 1394 port to the external-type connector.
Pin
Signal Names Pin Signal Names
1
3
5
7
9
2
4
6
8
10
USB Power 1
Negative Signal 1
Positive Signal 1
Ground 1
Key (No Pin)
USB Power 2
Negative Signal 2
Positive Signal 2
Ground 2
Empty Pin
4
Motherboard Pin Layout
1
2
9
10
Pin Signal Names Pin Signal Names
1
3
5
7
9
2
4
6
8
10
TPA+
Ground
TPB+
+12V
Key (No Pin)
TPA–
Ground
TPB–
+12V
Ground
Pin Assignment for Front Panel IEEE 1394 Connector
1
2
9
10