SLK2650-BQE User’s Manual Manuel de l’utilisateur Anwenderhandbuch Manuale per l’operatore Manual del usuario
At Antec, we continually refine and improve our products to ensure the highest quality. So it's possible that your new case may differ slightly from the descriptions in this manual. This isn't a problem; it's simply an improvement. As of the date of publication, all features, descriptions, and illustrations in this manual are correct. Installing the Motherboard This manual does not cover CPU, RAM, or expansion card installation.
connectors to the appropriate headers on your motherboard. You can use the LED I and LED II connectors as you see fit; as SCSI LED, Message LED, etc. or any other function supported by your motherboard, expansion cards, and peripherals. Connecting the USB Ports You'll find two 5-pin internal USB connectors (on separate cable sets) attached to the front USB connectors. Note: If you want to use both front USB connectors and the 8-in-1 card reader, your motherboard must have at least 3 internal USB headers.
recommend that you also install a NoiseKiller™ 80 kit. The rear fan is installed so that the air blows out of the case. Find a large 4-pin peripheral connector on the power supply and connect it to the male 4-pin connector on the fan. The front fan (optional) should be installed so that the air is blowing into the case from the front. To install it: 1. 2. 3. 3. Release the fan cage by squeezing the tabs. Put the fan in the cage and push it into place until it snaps tight. Snap the fan cage back into place.
