Specifications

CHAPTER 3 The DECADE controller 27
(AUTO) PRGR function
Scrolls through a time file (see page 37).
SET
DC STAT, AUTO RUN, PULS STAT, SCAN STAT) function
Returns to the previous (xx SET) screen.
SET1, SET2
PULS SET2, PULS STAT function
Returns to PULSE SET screen 1 or 2
START
AUTO RUN, SCAN STAT function
In the DC and pulse mode (master if cycles >1): toggles between STOP and
START to control the execution of a time file.
In the scan mode START starts a scan (see page 59).
STATUS
DC SET, PULS SET2, SCAN SET function
Enters the next (xx STAT) screen.
STOP
AUTO RUN, SCAN STAT function
In the scan mode, STOP aborts the scan and resets the cell potential to E1.
In the DC and pulse mode (master, cycles >1): toggles between STOP and
START to control the execution of a time file. Pressing ‘STOP’ aborts this run,
cycle counter (Cy) is not reset. By pressing the same button (‘START’) again,
the next cycle is started (Cy = Cy +1) (see page 37).
Software version 3.00 and higher: STOP also deactivates the outputs Aux 1
and 2, and Relays 1 and 2 (status: 0000). This toggle is also active in the
slave mode.
t1, t2
PULS SET2 control
Controls the duration of a corresponding step in the pulse mode. The time
can be set between 100 and 2000 ms in 10 ms increments (see page 51).
t3
PULS SET2 control
Controls the duration of a corresponding step in the pulse mode. The time
can be set between 0 (=off) and 2000 ms in 10 ms increments (see page 51).
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com