User`s manual

6
Note: The minimum voltage to start the fan is 5V. We recommend that our users
to set the fan speed to High if you choose to connect the fan to a fan control
device or to the Fan-Only connector found on some of Antec’s power supplies. A
fan-control device regulates the fan speed by varying the voltage to it. The voltage
may start as low as 4.5V to 5V. Connecting a TriCool™ set on Medium or Low
to a fan-control device may result in the fan not being able to start. The already
lowered voltage from the fan control device will be further reduced by the TriCool ™
circuitry below 5V.
Specifications:
Size: 120 x 120 x 25.4 mm
Rated Voltage: DC 12V
Operating Voltage: 10.2V ~ 13.8V
The Front 92 mm Fans
This case comes with two optional 92mm fan mounts in the front of the HDD
cage. The front fan should be installed so that the air is blowing into the case from
the front. We recommend using Antec TriCool™ 92 mm fans and set the speed to
LOW.
1. Remove the HDD cage from the case. Note: there is no need to remove the
front bezel in order to install the fan.
2. Find four special fan screws inside the tool bag and mount the fan to the
front panel from inside of the case.
3. Replace the HDD cage.
Speed
Input
Current
Air Flow
Static
Pressure
Acoustical
Noise
Input
Power
High
2000 RPM
0.24 A
(Max.)
2.24 m³ / min
(79 CFM)
2.54 mm-H2O
(0.10 inch-H2O)
30 dBA 2.9 W
Medium
1600 RPM
0.2 A
1.59 m³ / min
(56 CFM)
1.53 mm-H2O
(0.06 inch-H2O)
28 dBA 2.4 W
Low
1200 RPM
0.13 A
1.1 m³ / min
(39 CFM)
0.92 mm-H2O
(0.04 inch-H2O)
25 dBA 1.6 W