User’s Manual Manuel de l’utilisateur Anwenderhandbuch Manuale per l’operatore Manual del usuario
At Antec, we continually refine and improve our products to ensure the highest quality. So it's possible that your new case may differ slightly from the descriptions in this manual. This isn't a problem; it's simply an improvement. As of the date of publication, all features, descriptions, and illustrations in this manual are correct. Disclaimer This manual is intended only as a guide for Antec's Computer Enclosures.
CONNECTING THE POWER AND LED 1. Connect the 24-pin or 20-pin ATX power connector and +12V 4-pin connector to your motherboard. Note: an ATX12V v2.0 power supply comes with a 24-pin power connector. This is the latest Intel form factor power supply. 2. Connect the Reset switch (labeled RESET SW) to your motherboard at the RST connector. Make sure the label always faces the front of the case. 3. Power LED (labeled POWER LED) connector is located behind the Reset connector. 4.
1 9 2 Motherboard Pin Layout for Front Panel IEEE 1394 Connector Pin Signal Names Pin Signal Names 1 TPA+ 2 TPA– 3 Ground 4 Ground 5 TPB+ 6 TPB– 7 +12V (Fused) 8 +12V (Fused) 9 Key (No Pin) 10 Ground 10 CONNECTING THE AUDIO PORTS There is an Intel standard 10-pin connector (with 7 individual wires with connectors) coming out from the front panel speaker and microphone connection If your motherboard supports Intel's standard onboard audio connector, you can plug in the 10-pin conn
6. Mount your other 3.5" devices into the drive cage. 7. Slide and lock the drive cage back into the case. 8. Find the proper connector on the power supply (SATA, floppy, or standard 4-pin) and connect it to the male connector on your device. 5.25" DEVICE INSTALLATION 1. Take off the plastic drive bay covers and metal plates as described above. 2. Take two of the drive rails and mount them to the sides of the 5.25" device. Make sure the metal portion is angled away from the device and facing forward. 3.
VGA Card Cooling There is an 80mm fan mount with vents on the clear side window right above the VGA card. The vents can supply fresh air to the card without a fan (passive cooling), or with a fan (active cooling) if you are using a high performance VGA card that needs extra cooling. Install the fan so that the air is blowing into the case. We recommend using an Antec 80mm TriCool fan. Maintaining the Washable Air Filter From time to time it will be necessary to wash the installed air filter.
Antec, Inc. 47900 Fremont Blvd. Fremont, CA 94538 Tel: 510-770-1200 Fax: 510-770-1288 Antec Europe B.V. Sydneystraat 33 3047 BP Rotterdam The Netherlands Tel: +31 (0) 10 462-2060 Fax: +31 (0) 10 437-1752 Technical Support US & Canada 1-800-22ANTEC CustomerSupport@antec.com Europe +31 (0) 10 462-2060 europe.techsupport@antec.com www.antec.com © Copyright 2005 Antec, Inc. All rights reserved. All trademarks are the property of their respective owners.
