TM Media Components Fusion 430 /Fusion Black 430 User’s Manual Manuel de l’utilisateur Anwenderhandbuch Manuale per l’operatore Manual del usuario পᡅ䂀ᯢ
At Antec, we continually refine and improve our products to ensure the highest quality. As such, it’s possible that your new case may differ slightly from the description in this manual. This isn’t a problem; it’s simply an improvement. As of the date of publication, all features, descriptions, and illustrations in this manual are correct. Disclaimer This manual is intended only as a guide for Antec’s Computer Enclosures.
The Triple Chamber structure Upon opening the top panel, you will find that the case is divided into three chambers – the power supply chamber, the motherboard chamber and the HDD chamber. This triple chamber structure isolates the heat and noise within each chamber, resulting in much quieter and cooler operation than a traditional desktop case design. Installing the Motherboard This manual does not cover CPU, RAM, or expansion card installation.
5. reversing the connection. For more info on connecting LEDs to your motherboard, see your motherboard manual. The Hard Drive LED (labeled HDD LED) connects to the hard drive activity header. Power Supply 3-Pin Fan Signal Connector A three-pin fan signal connector with blue and black wires is available to connect the power supply to one of your motherboard’s fan connectors (Note: Some motherboards have a dedicated fan connector labeled PWR_FAN or PSU_FAN that is specifically for the power supply).
FireWire port to an IEEE 1394 add-on card that comes with an external-type IEEE 1394 connector, you will need a FireWire Internal Adapter. To order one, please visit Antec’s web store at http://www.antec.com/StoreFront.bok and search for part number 30031. This adapter will allow you to connect the front IEEE 1394 port to the external-type connector.
1. 2. 3. 4. 5. 6. 7. Make sure the power supply is off and unplugged before installing any hardware. Connect the 3-pin power cable from the display to the 3-pin connector on the 24-pin ATX main power connector of the power supply. Note: If you choose to swap the included power supply with another power supply, please call Antec Customer Service to purchase a special 24-pin Extender with the 3-pin connector to power the display.
3. Find a 4-pin molex or SATA connector on the power supply and connect it to the power connector on the device. Cooling System The 120mm TriCool™ fans The Fusion 430 comes with two 120mm TriCool™ fans preinstalled at the side of the case inside the motherboard chamber. These two fans are preinstalled at the side of the case next to the CPU for effective CPU cooling and have a three-speed switch that allows you choose between quiet, performance, or maximum cooling (Please see specifications below).
When used with the CPU Air Guide, fresh air from the rear air intake can be directed to the CPU cooler to enhance the CPU cooling. The CPU Air Guide can be adjusted by adding or removing stacking sections to best suit different motherboard CPU positions. The Power Supply Air Intake There are vents on the left side of the case to bring cool air into the power supply chamber to cool the power supply. Note: Please leave at least 1” (2.
Antec, Inc. 47900 Fremont Blvd. Fremont, CA 94538 USA tel: 510-770-1200 fax: 510-770-1288 Antec Europe B.V. Stuttgartstraat 12 3047 AS Rotterdam The Netherlands tel: +31 (0) 10 462-2060 fax: +31 (0) 10 437-1752 Customer Support: US & Canada 1-800-22ANTEC customersupport@antec.com Europe +31 (0) 10 462-2060 europe.techsupport@antec.com www.antec.com © Copyright 2007 Antec, Inc. All rights reserved. All trademarks are the property of their respective owners.
