Instruction Manual

Duration Time Setup - Press the [Menu] button until the LCD screen displays “Duration

Set” and press the ▲ or ▼ button to set the duration time from 2-15 seconds.

Output Volume Setup - Press [Menu] until the LCD screen displays “Timer Output” and

press the ▲ or ▼ button to set the output percentage from 50-100%.

After finishing the above setting, go back to the main screen by pressing the [Stop] button.

To activate Timer Mode, press the [Timer] button below the display. To deactivate Timer

Mode, press [Stop] button.

Volume Operation

To operate the machine in Volume Mode, the output volume under Volume Mode must be

set first:

Output Volume Setup - Press the [Menu] button until the LCD screen displays “Volume

Output” and then press the ▲ or ▼ button to set the output percentage from 50-100%.

After finishing the above setting, go back to the main screen by pressing the [Stop] button.

To activate Volume Mode, press the [Volume] below the display. To deactivate Volume

Mode, press the [Stop] button.

Note: In Volume Mode, the machine emits fog continuously until a re-heat is needed.

2-Second Jet Operation

To activate 2-Second Jet Mode, press the [Menu] button until the LCD screen displays

“2-Second Jet Output” and then press the ▲ or ▼ button to activate or deactivate

2-Second Jet Mode. Once the 2-Second Jet Mode is activated, the main screen will keep

showing “2-Sec Jet Mode”. Press the [Volume] button and the fog will be emitted for 2

seconds with maximum output (100%).

DMX Operation

Making the DMX Connection – Connect machine to a DMX controller or to one of the

machines in the DMX chain. The machine uses an 3-pin and 5-pin XLR connector for DMX