User manual

shipment) to control machine, the setting must be completed within 15
seconds after switching on the machine otherwise it will leave
“transmitter setting mode” automatically.
There is a LED light on the rear control panel of the machine. When the
machine is turned on, the LED green light will flash for 15 seconds.
During the 15 seconds interval, users can register signals for the
transmitters. If the registering signal of transmitter is well-received by
the receiver, the LED light will stop flashing and fixed green light will
appear. If user desires to use 1 transmitter to control 2 or more
machines at the same time, user has to turn on 2 (or more) machines
altogether, and press the button “A” of the transmitter within 15
seconds to set the signals.
5. If no any other new transmitter is registered when machine is switched
on, the memory of the receiver will remain the same record of the last
operation.
6. Please note if a new transmitter is registered when machine is switched
on, no matter how many new transmitters is registered (at most 5), all
previous transmitters registered record will be cleared (overridden)
Save these instructions
Setting Example :
Specifications
AC 120V/90Hz (120V Model)
AC 230V/50Hz (230V Model)
F2A/250V (120V Model)
T1A/250V (230V Model)
241x170x172
Net 3.4kg. Gross 4.2kg
On / Off only; no DMX
Standard W-1 Wireless Controller
Not Available
1 Liter
Power
Fuse
Dimensions(mm)
Weight
Function
Remotes
Optional Remotes
Tank Capacity