W-101 Bubble Machine User Manual Please read and save these instructions. Antari Lighting and Effects Ltd.
User Manual W-101 Bubble Machine Congratulations on the purchase of your new ANTARI W-Series bubble MACHINE. Introduction Thank you for choosing an ANTARI W-Series Bubble Machine. You now own a rugged and powerful state-of-the-art bubble machine. Prior to use, we suggest that you carefully read all of the instructions. By following the suggestions found in this user manual, you can look forward to the reliable and satisfactory performance of your ANTARI Bubble Machine for years to come.
For indoor use only. Not designed for outdoor use. This appliance must be earthed. For adult use only. The bubble machine must be installed out of the reach of children. Never leave the unit running unattended. Never aim the output at open flames. Extended use will make all surfaces slippery. Please kindly pay attention. Position output of bubbles away from people. Switch off from mains when refilling the liquid or cleaning the system. Regular cleaning of the bubble wheel is required.
W-101 Hanging Bracket: Your model includes a mounting bracket designed for overhead installation; it may be installed at floor level or suspended overhead. If the unit is to be mounted using the bracket, it is important that the fog does not shoot directly at any one's face. Whatever installation method you choose, do not allow the unit to have more than a 25 degree angle of inclination. W-101 External View 01. Body 03 02. Spout 02 03. Yoke 04. Tightening screw 05 05. Washer 06. Pilot lamp 07.
Safety Screw Finger Screw To help avoid accidental exposure to dangerous live AC mains voltage, two safety screws are fitted that require a screwdriver to remove. Once these are removed, the finger screws can be undone by hand (see photo above). Once the screws are removed, the lid of the housing can be carefully swung upwards, as shown above. Take care not to spill any of the bubble fluid inside the unit. The fluid tank is designed to fit only one way around.
Please now refer below of “Instructions of Antari Wireless Remote for W-101” for setting for the remote controller command. INSTRUCTION OF ANTARI WIRELESS REMOTE FOR W-101 * Transmitter: - Transmitter: Use DC 12V battery - Working Distance: 50 meters in open area (wireless distance may vary depending on the interference) - All transmitters are compatible to any receiver * Receiver: - The receiver is pre-equipped firmly and tested to each of the W-101 (rear panel), please do not try to remove it.
shipment) to control machine, the setting must be completed within 15 seconds after switching on the machine otherwise it will leave “transmitter setting mode” automatically. Setting Example : There is a LED light on the rear control panel of the machine. When the machine is turned on, the LED green light will flash for 15 seconds. During the 15 seconds interval, users can register signals for the transmitters.
Warranty Warranty shall be valid only if the product is purchased from Antari's authorized distributors or dealers. For warranty service, send the product only to an authorized distributor or dealer. All warranties are void if the product has been modified in any manner; if the product has been repaired or serviced by unauthorized personnel; or the product is damaged due to improper use or maintenance as set forth in the instruction manual.
For current product information visit Antari at : www.antari.com , www.antari.com.tw For information requests please contact us at : sales@antari.
