User manual

7
output is decreased, bigger snow flakes will be produced. However, the snow output volume will not be
affected.
Note: When the machine senses no fluid in the fluid pipe, LCD screen will blink and show ƒNo Fluid„.
Meanwhile, the machine is locked and not able to output for preventing machine from further ineffective work.
Check immediately if the snow fluid in tank has been run out. To unlock the LCD screen, press Stop for
2 seconds and the machine will try to pump again the snow fluid. When the fluid pipe is full of snow fluid then
the machine will be functional again.
REMOTE CONTROL OPERATION
W-1: The wireless remote control W-1 consists of a transmitter equipped with two buttons for output on and off,
and a receiver pre-attached to SW-250.
* Transmitter
With the transmitter it is possible to output via radio over a distance of up to 50 meters. The transmitter is
compatible to any receiver of SW-250 and can control an unlimited number of machines in parallel. Press the
button ƒA„, toouput. As control, the LED on the transmitter is lit. To stop the output, press the button ƒB„.
* Receiver
The receiver is tested and built in SW-250. Please do not try to remove it. The receiver responds to up to 5