Owner's manual

Open the shipping carton and check that all equipment necessary to operate the machine have arrived intact.

The shipping carton should contain the following items:

1. Snow machine with power cable

2. W-1 wireless transmitter (Only for SW-250 model)

3. Fluid tank

4. Hanging bracket

5. Screw set and user manual

Before beginning initial setup of your ANTARI SW-250 Snow Machine, make sure that there is no evident

damage caused by transportation. In the event of that the unit's housing or cable is damaged, do not plug it

nor use it until contacting your Antari dealer for assistance.

SETUP and POWER ON

1. Remove all packing materials from shipping box. Check that all foam and plastic paddings are removed.

2. Place the machine on a flat surface and follow steps below.

Tank cap

Tank

Filter

PU Liquid Tube

Adaptor

with Nut

Assembling Tank & Filter

Please note that "adaptor with nut"

set must be tightly connected.

3. Assemble the hanging bracket on the machine, use the M8 screws to position the hanging bracket

with the machine, the tightening screws are for adjusting the machine’s angle when in the air.

Assembling Hanging Bracket

Assemble 4 washers on both inner sides of the hanging

bracket w ith M8 screw s on outer sides as indicated.

Hanging Bracket

M8 Screw

Tightening

Screw

Washer

4. Fill with ANTARI SL-5(A) snow fluid. Any other types of fluid can damage the unit. When filled, place cap