User manual

ManualsBrandsAntari ManualsFog MachineOnboard DMX

Z-1500II and Z-3000II USER MANUAL

Z-1500II und Z-3000II BEDIENUNGSANLEITUNG

Mode D’Emploi des Z-1500II et Z-3000II Machines à Fumée

Congratulations on the purchase of your new

ANTARI Z-SERIES II FOG MACHINE.

Wir beglückwünschen Sie zum Kauf Ihres neuen ANTARI Z-SERIES II NEBELGERÄTES.

Nous vous félicitons pour l’achat de votre nouvelle

Z-SERIES II machine à fumée d’ANTARI.

♦ Read and save these instructions

♦

♦♦

♦ Bitte lesen Sie diese Anweisungen und bewahren Sie sie gut auf

♦

♦♦

♦ Lisez et Gardez ces instructions





 2005 Antari Lighting and Effects Ltd.

Summary of content (7 pages)

PAGE 1
Z-1500II and Z-3000II USER MANUAL Z-1500II und Z-3000II BEDIENUNGSANLEITUNG Mode D’Emploi des Z-1500II et Z-3000II Machines à Fumée Congratulations on the purchase of your new ANTARI Z-SERIES II FOG MACHINE. Wir beglückwünschen Sie zum Kauf Ihres neuen ANTARI Z-SERIES II NEBELGERÄTES. Nous vous félicitons pour l’achat de votre nouvelle Z-SERIES II machine à fumée d’ANTARI.
PAGE 2
User Manual Antari Z-1500II and Z-3000II Fog Machine Congratulations on the purchase of your new ANTARI Z-Series II FOG MACHINE. Introduction Thank you for choosing ANTARI Z-Series II Fog Machine. You now own a rugged and powerful state-of-the-art machine. Prior to use, we suggest that you carefully read all of the instructions. By following the suggestions found in this user manual, you can look forward to the reliable and satisfactory performance of your ANTARI Fog Machine for years to come.
PAGE 3
♦ If the supply cord is damaged, it must be replaced by manufacturer or its service agent or similarly qualified personnel in order to avoid a hazard. ♦ The output nozzle becomes very hot during operation (300°C). Keep flammable materials at least 50 cm away from the nozzle. ♦ Always allow your ANTARI Fog Machine to cool down before attempting to clean or service it. Danger of Explosion ♦ Never add flammable liquids of any kind (such as oil, gas, perfume) to the fog liquid.
PAGE 4
♦ For further information on operating your Z-1500II, Z-3000II Fog Machine, see the section titled “Remote Control Operation”. CAUTION: “Visibility during operation is reduced” This model can be operated at a floor level or sitting on any regular surface. Whatever installation method you choose, do not allow the unit to have more than 15 degree angle of inclination. Important: Always monitor tank fluid level as you are fogging. Running a fog machine with no fluid can permanently damage the unit.
PAGE 5
Z-20: 1. LCD-Display 2. FUNCTION-Button 3. UP-/DOWN-Button 4. TIMER-Button 5. VOLUME-Button 6. MANUAL-Button 1. Via the FUNCTION Button, you can adjust the desired settings. Pressing the FUNCTION Button will cycle through different options including Volume, Timer, Heat & Fan. The ENTER (VOLUME) Button is used to select the desired option. To adjust fog output volume setting, simply go into VOLUME option. Adjust the volume percentage (within the range of 1% to non-stop burst) by means of UP/DOWN Buttons.
PAGE 6
a cleaning solution composed of 80% distilled water and 20% white vinegar through the system to prevent the accumulation of particulate matter in the heating element. The recommended cleaning regimen is as follows: Empty all fog liquid from machine. Add cleaning solution to tank. Plug unit in and begin warm up. Run unit in a well-ventilated area until tank is almost empty. Do not allow the pump to run dry. Replace nozzle. Cleaning is now complete. Refill with fog liquid.
PAGE 7
Antari Z-1500II, Z-3000II on-board DMX Fog Machine Settings DMX Setting for Z-1500II & Z-3000II fog machines with on board DMX Channel A 0 - 5 = OFF 6 – 249 = Volume Control ( 5% - 95%) 250 – 255 = Maximum Volume Output (100%) The Z-1500II & Z-3000II Fog Machines have on-board DMX control. These two models use 1 channel to control volume output operation. Each channel has a value range of 0 to 255.