User manual

5
 To select operation mode 1. Slide the switch towards the back of the M-1 (towards the cap on the liquid
tank).
 To select operation mode 2. Slide the switch towards the front of the M-1 (towards the nozzle).
 When an optional remote is connected, please see the detailed instructions for their operation below.
 The machine will fo until the battery charge runs down or the M-1 runs out of fog liquid. When the M-1 is
connected to the optional power adaptor, carefully monitor the level of the fog liquid to make sure the machine
does not run out of liquid. Operating continuously, the machine will run out of liquid in approximately 50
minutes.
 A full battery charge will power the M-1 for a period of 10-12 minutes before needing to be recharged. When
using the battery, the charge will run down several times before the fluid needs to be refilled.
Note: There is no warm-up time with the M-1 Mobile Fogger. Unlike most other fog machines,
you do not have to wait for the heater to warm-up before fogging.
Installation
 The M-1 Mobile Fogger can be carried in hand or installed in a fixed location as desired.
 Wherever the machine is placed, it is important that fog does not shoot directly at any one’s face, at open
flames or directly into any heat susceptible material.
 The machine can be held or installed at any angle. After refilling the liquid tank, screw the cap on tightly.
Failing to do so will result in leakage if the machine is placed at an angle.
Optional Remote Control Operation
There are two optional remote controls designed for the M-1 Mobile Fogger.
1. MCT-1 Timer Remote Control: This remote control is connected via an 8-meter cord. The duration
of the fog blast is set at 10 seconds. The interval is controlled by the dial on the remote and is adjustable
between 3 and 220 seconds.
2. MCR-1 Wireless Remote Control: This remote control consists of two components. The transmitter is
on a small key chain and has a range of up to 50 meters from the receiver. The receiver connects to the
side of the M-1 Mobile Fogger and can attach to the M-1’s case via a magnetic strip. Pressing the
remote control’s button once starts the M-1 fogging. A second press stops the M-1’s fog output.
Warning: The battery must be removed and the power adaptor unplugged before connecting or
disconnecting either of the remote controls to the M-1 Mobile Fogger.
Caution
 Always monitor tank fluid level as you are fogging. Running a fog machine with no fluid can permanently
damage the unit.