User manual
3
Never aim the output nozzle directly at people.
Fog machine output is hot. Avoid coming within 50 cm of the output nozzle during operation.
Place the fog machine in a well-ventilated area. Never cover the vents on the front of the M-1. Never aim
the output nozzle at open flames.
The output nozzle becomes hot during operation. Keep flammable materials at least 50 cm away from the
nozzle.
Always allow your Antari Fog Machine to cool down before attempting to clean or service it.
Danger of Explosion
Do not expose the battery to excessive heat, keep away from open flames and do not attempt to remove the
case.
Never add flammable liquids of any kind (oil, gas, perfume) to the fog liquid.
Use only the high quality, water/glycol based fog liquid that your Antari dealer recommends. (For M-1 only
FLM-05) Other fog liquids may generate a poor fog effect, clog the internal components or “spit” fog liquid.
Always make sure there is sufficient liquid in the fog liquid tank. The fluid level can be monitored via the
window at the back of the machine.
Operating this unit without liquid will cause damage to the pump and the heater.
If your Antari M-1 MobileFog Machine fails to work properly, discontinue use immediately. Drain all fog
liquid from the tank, pack the unit securely (preferably in the original packing material), and return it to your
Antari dealer for service.
Always drain fog liquid from the tank before shipping or transporting this unit.
Never drink fog liquid. If it is ingested, call a doctor immediately. If fog liquid comes in contact with skin
or eyes, rinse thoroughly with water.
Unpacking & Inspection
Open the shipping carton and check that all equipment necessary to operate the system has arrived intact. In
addition to this user manual, you should receive the following items:
1. M-1 Mobile fogger
2. 12V – 2.3Ah rechargeable battery
3. Rechargeable battery charger
4. Power cable for the battery charger
5. 500 cc bottle of Antari fog liquid
6. Briefcase sized Mobile Fogger flight case
Before beginning initial setup of your Antari M-1 Mobile Fog Machine, make sure that there is no evident
damage caused by transportation.
In the event that the unit’s housing or cable is damaged, do not plug it in and do not attempt to use it until after
contacting your Antari dealer for assistance.