User manual

Please make sure that you do not have any overlapping channels in order to
control each machine correctly and independently from any other fixture on the
DMX data link. If two, three or more devices are addressed similarly, they will
work similarly.
Occupation of the DIP switches:
Performance Note
All fog machines develop condensation around the output nozzle. Because this
may result in some moisture accumulation on the surface below the output
nozzle, consider this condensation when installing your unit.
All fog machines may sputter small amounts of fog occasionally during
operation and for a minute or so after being turned off.
All fog machines have a recycling period after long bursts when the machine
will shut itself down for a short period in order to heat up again. During this
time no fog can be produced.
Cleaning and Storage
Do not allow the fog liquid to become contaminated. Always replace the cap on
the fog liquid container and the fog machine liquid tank immediately after
filling. Cleaning your fog machine regularly can help you to reduce the
frequency of parts replacement and maintenance costs. After every 40 hours of
continuous operation, it is recommended to use distilled water to clean the
heater according to the steps below.
Setting the DMX-
starting address:
DIP-switch no.
Device number
& channels
Starting address
Device 1 - Channel 1
ON
OFF
1
1
2
2
3
4
4
8
5
16
6
32
7
64
8
128
9
256
Device 2 - Channel 2
ON
OFF
Device 3 - Channel 3
ON
OFF
Device 4 - Channel 4
ON
OFF
Device 5 - Channel 5
ON
OFF
-08-