User manual

Performance Note
Cleaning and Storage
All fog machines develop condensation around the output nozzle. Because
this may result in some moisture accumulation on the surface below the
output nozzle, consider this condensation when installing your unit.
All fog machines may sputter small amounts of fog occasionally during
operationandforaminuteorsoafterbeingturnedoff.
Allfogmachineshavearecyclingperiodafterlongburstswhenthemachine
wil shutitselfdownforashortperiodinordertoheatupagain.Duringthis
time no fog can be produced.
Do not allow the fog liquid to become contaminated. Always replace the caps on
the fog liquid container and the fog machine liquid tank immediately after
filling. Cleaning your fog machine regularly can help you to reduce the
frequency of parts replacement and the cost of maintenance. After every 40
hours of continuous operation, it is recommended to use distilled water to clean
the heater as per following steps:
1. Fill proper distilled water into a clean tank and connect the fluid tube of the
fog machine to the tank.
2.Runtheunitinawell-ventilatedareauntilthetankisalmostempty.
All fog machines are prone to clogging due to the thick consistency
offogliquidandthehightemperatureatwhichitvaporizes.
However,aproperlymaintainedfogmachineshouldprovideyears
of reliable use.
If the fog machine is not in use, please clean it before storage.
Storethefogmachineinadryandcoolplace. Atleastoperatethe
fog machine once a month. A test-run consisits of warming-up the
machine followed by a few minutes of fog emission.
Please read and save these instructions.
The recommended cleaning regimen is as follows:
Note:
Clean with a dry cloth only. Store dry.
3. Use dry cloth to wipe the fog machine. Cleaning is now complete. Refill
with fog liquid. Run the machine briefly to clear any remaining liquid from
the pump and heater.
-07-