User manual

Note:
Instruction of Antari Wireless Remote for W-508 & W-510
* Transmitter:
* If you experience low output, pump noise or no output at all, unplug
immediately. Check fluid level, the external fuse, and power from the wall.
If all of the above appears to be O.K., plug the unit again. If fog does not
come out after holding the remote button down for 30 seconds, check the
hose attached to the tank to make sure there is fluid going through the
hose. If you are unable to determine the cause of the problem, do not
simply continue pushing the remote button, as this may damage the unit.
Return the machine to your ANTARI dealer.
-Transmitter:UseDC12Vbattery
- Working Distance: 50 meters in open area (wireless distance may vary
depending on the interference)
- All transmitters are compatible to any receiver
An optoelectronic (OPTO) liquid sensor is installed to both W-508 &
W-510. The pump will automatically stop working and the LED light
indicator on the rear of the machine will start to flash when there’s
insufficientliquid. Pleaserefilltheliquidtotheemptytankand
restart (turn off then turn on) to dis-alarm the LED indicator.
Thenthemachineisreadytooperateagain.
Technical Specifications
Model
Power Supply
Power Consumption
Output Volume
Tank Capacity
Fluid Consumption
Weight
Dimensions (LxWxH)
Remote Included
Warm-up Time
W-508
100~240V AC 50/60 Hz
800 W
3,000 cu.ft/min (85 m³/min)
0.8 liters
60 min /0.8 liter
3.8 kg
315 x 128 x 166 (mm)
W-1
100 seconds
W-510
100~240V AC 50/60 Hz
1,000 W
10,000cu.ft/min (284 m³/min)
2.8 liters
13 min / liter
11.4 kg
468 x 250 x 148 (mm)
W-1
12min
-05-