User manual

Addressing
Each device occupies 1 channel. To ensure that the control signals are
properly directed to each device, they require adressing. This is to be
adjusted for every single device by changing the DIP-switches as set out in
the table below.
The starting address is defined as the first channel from which the device will
respond to the controller.
Please make sure that you do not have any overlapping channels in order to
control each device correctly and independently from any other fixture on the
DMX data link. If two, three or more devices are addressed similarly, they will
work similarly.
Occupation of the DIP-switches:
Setting the DMX-
starting address:
DIP-switch no.
Device number
& channels
Starting address
Device 1 - Channel 1
ON
OFF
1
1
2
2
3
4
4
8
5
16
6
32
7
64
8
128
9
256
Device 2 - Channel 2
ON
OFF
Device 3 - Channel 3
ON
OFF
Device 4 - Channel 4
ON
OFF
Device 5 - Channel 5
ON
OFF
-09-