User Manual for LCU-1 Liquid Control Unit Congratulations on the purchase of your new ANTARI LCU-1 Liquid Control Unit.
User Manual Antari LCU-1 Liquid Control Unit Congratulations on the purchase of your new ANTARI LCU-1 Liquid Control Unit. Introduction Thank you for choosing an ANTARI Liquid Control Unit. You now own a rugged and powerful state-of-the-art machine. Prior to use, we suggest that you carefully read all of the instructions. By following the suggestions found in this user manual, you can look forward to the reliable and satisfactory performance of your ANTARI Liquid Control Unit for years to come.
♦ Keep this device dry. ♦ For inside use only. Not designed for outside use. ♦ For the 110V models, use 3-prong grounded electrical outlet only. Prior to use take care to determine that the unit is installed at the rated voltage. ♦ Keep Liquid Control Unit upright. ♦ Turn off or unplug when not in use. ♦ This machine is not water- or splash-proof.
Pay attention to all warning labels and instructions printed on the exterior of your ANTARI Liquid Control Unit ♦ Maximum pressure of the pump inside the machine is 7 BAR. ♦ Maximum fog output is 20,000 cubic feet/minute. ♦ Visibility during operation is reduced. ♦ Use only the high-quality, water-based fog liquid that your dealer recommends. Other fog liquids may cause clogging or “spitting”. ♦ Operating this unit without liquid will cause damage to the pump.
♦ Remove all packing materials from shipping box. Check that all foam and plastic padding is removed. ♦ Place Liquid Control Unit on a flat surface. ♦ Put a Tank beside Liquid Control Unit and connect a 6mm PU tube between Tank & Liquid Input Adapter ♦ Connect 6mm PU tube from Liquid Output Adapter then extend this tube to four Z-1200 fog machine (S-100IIs / ICEs). Each terminal use FT-6 , FTA-64 and FTA-664 divide liquid flow direction.
♦ Plug power cord into a grounded electrical outlet. If necessary, turn power switch on rear of unit to “ON” position. ♦ To extrude liquid, press the appropriate button on the remote for the desired length of time. ♦ For further information on operating your ANTARI Liquid Control Unit, refer to the Antari onboard, “Remote Control Operation”. ♦ For details regarding DMX, refer to the Antari onboard DMX fog machine settings section.
through the system to prevent the accumulation of particulate matter in the tube. The recommended cleaning regimen is as follows: 1. While unit is unplugged and clean out debris with vinegar and a pipe cleaner, making sure that the tube is free of clogs. 2. Add cleaning solution to tank. Run unit in a open area until tank is empty. 3. Cleaning is now complete. Refill with fog liquid. Clean with a dry cloth only. Store dry.
C08LCU1 8
