Owner`s manual

50
Pressing the Gate button again while the Gate Page is displayed will
display the Gain Reduction Meter Page (see below). Continually pressing
the Gate button will alternate between the two pages.
The ranges of the parameters are as follows:
Threshold: -90dB - 0dB
Ratio: 1:1.0 - 1:99
Gain Reduction Meter Page
C/G:-20 -12 -6 -3 0
Pressing either the Comp. or Gate buttons while their respective pages are
displayed will display this high resolution gain reduction meter. The meter
displays the amount of gain reduction applied to the signal. When the
input signal is above the compression threshold or below the gate thresh-
old, the gain reduction meter will display the amount of compression or
gating being applied. Pressing the Comp. or Gate button again will return
to the appropriate page.
Gain Reduction Meter
The front panel gain reduction meter is intended to provide a quick
indication of compressor and gate activity. For precise gain reduction
indication, refer to the Gain Reduction Meter Page described above. The
range of the meter is 15 dB.
Comp/Gate On Button
When this button is lit, the Comp/Gate module is active. When it is not lit,
the module is bypassed. Pressing the button toggles its state. The Comp/
Gate On/Off function can also be controlled by MIDI and/or by a
footswitch.