Owner`s manual

48
Correction Meter
This meter indicates, in real time, the amount of pitch correction being
applied to change the input pitch to the target pitch. The green LEDs
indicate that the input is flat and that positive correction is being applied.
Conversely, the yellow LEDs indicate that the input is sharp and that
negative correction is required.
Auto-Tune On Button
When this button is lit, the Auto-Tune module is active. When it is not
lit, the module is bypassed. Pressing the button toggles its state. The
Auto-Tune On/Off function can also be controlled by MIDI and/or by a
footswitch.
COMPRESSOR/GATE MODULE
Compressor Page
Th:-12dB
Ratio: 3.0:1 Gn:12dB
This page allows you to set the main compressor parameters. Use the
cursor buttons to move from field to field and the Data Knob to set each
parameter. For ease in setting the threshold, this page includes a display of
the incoming signal level and a graphic indication of the currently selected
threshold. The threshold must be set below the signal peaks for any
compression to occur.
Pressing the Comp. button again while the Compressor Page is displayed
will display the Gain Reduction Meter Page (see below). Continually
pressing the Comp. button will alternate between the two pages.
The ranges of the parameters are as follows:
Threshold: -36dB - 0dB
Ratio: 1.0:1 - 99:1
Makeup Gain: 0dB - 36dB
Compressor Attack Page
Compressor Attack
40ms