Owner`s manual

34
The following parameters can be controlled via MIDI:
Auto-Tune Speed De-esser High Pass Frequency
Auto-Tune ON/OFF De-esser Attack
Tube Warmth De-esser Release
Source Mic Proximity De-esser ON/OFF
Model Mic Proximity EQ1 Frequency
Mic Mod ON/OFF EQ1 Q
Compressor Threshold EQ1 Slope
Compressor Ratio EQ1 Gain
Compressor Makeup Gain EQ2 Frequency
Compressor Attack EQ2 Q
Compressor Release EQ2 Slope
Gate Threshold EQ2 Gain
Gate Ratio EQ ON/OFF
Comp/Gate ON/OFF Double Track Mix
De-esser Threshold Double Track ON/OFF
De-esser Ratio Output Gain
Footswitch Assign Page
Footswitch Assign
Main Bypass OFF
To assign a footswitch to control one or more AVP functions, use the Data
Knob to select the desired function and then press the > (Right Cursor)
button to move to the ON/OFF field and select ON.
The following functions can be controlled by a footswitch:
Main Bypass Comp/Gate ON/OFF
Increment Preset De-esser ON/OFF
Mic Mod ON/OFF EQ ON/OFF
Auto-Tune ON/OFF Double Track ON/OFF
NOTE: Engaging Main Bypass via the footswitch results in the display of
the Main Bypass screen and locks out all other button presses until
Bypass is disengaged (either via the footswitch or a physical button
press).
For maximum flexibility, it is possible to assign the footswitch to multiple
parameters. You would typically use this capability to turn multiple
modules on or off with a single press of the footswitch. However, it is also
possible to assign the footswitch to combinations of functions that don’t
make much practical sense. Specifically, be aware of the following: