Owner`s manual

For this configuration, your mixer must provide direct channel outputs.

Patch the direct output of the channel whose signal you want to process

to the Line Input of the AVP. Patch the Main Output of the AVP to the line

input of a second mixer channel. Use the fader of the first channel to set

the input level of the AVP. Be sure that the first channel is not assigned to

the main mix.

NOTE: If you will be using the AVP’s Double Tracking function in stereo

mode, patch the AVP’s Double Track output to a third channel on your

mixer.

With an external mic preamp or instrument

If you are recording directly to a tape deck or hard disk recorder, patch the

output from an external mic preamp or instrument (at line level) into the

AVP’s Line Input and the AVP’s Main Output into your recorder. If you will

be using the AVP’s Double Tracking function in stereo mode, patch the

AVP’s Double Track output to a separate channel on your recorder.

AN IMPORTANT NOTE ABOUT MONITORING: If the AVP is used to

Auto-Tune an artist’s performance in real time, it is important that

the performer is able to monitor their original signal, not the pitch-

corrected signal. Trying to react musically to the processed signal will

drive them crazy and, in most cases, drive them farther off pitch.

CHANNEL 1

AVP

RECORDER

MIC PREAMP OR

INSTRUMENT

INPUT

MAIN OUTPUT

DOUBLE TRACK

OUTPUT

CHANNEL 2

OPTIONAL

WITH AN EXTERNAL

MIC PREAMP OR

INSTRUMENT