Owner`s manual

26
If your mixer has separate insert send and insert return jacks, patch the
insert send to the AVP’s Line In and the AVP’s Main Line Out to the mixer’s
insert return.
If (as is more common) your mixer has a single insert jack, you will need a
“Y” cable with one 1/4" TRS (Tip, Ring, Sleeve) phone plug and two 1/4"
TS phone plugs. Insert the TRS plug into the mixer’s insert jack and insert
the appropriate TS jacks into the AVP’s Line In and Line Out jacks (i.e., the
mixer’s insert send to AVP Line In and the mixer’s insert return to AVP
Main Line Out.)
NOTE: In most cases, a mixer’s insert send will appear on the tip of the
TRS plug and the insert return on the ring. However, you should consult
your mixer’s manual to confirm that this is indeed the case for your
mixer.
In this configuration, you should use your mixer’s channel trim to set the
input level of the AVP.
NOTE: If you will be using the AVP’s Double Tracking function in stereo
mode, patch the AVP’s Double Track output to a separate channel on
your mixer.
As an insert effect using two mixer channels
CHANNEL 1
AVP MIXER
INPUT
INSERT
SEND/RETURN
INSERT
SEND/RETURN
INPUT
MAIN OUTPUT
DOUBLE TRACK
OUTPUT
CHANNEL 2
INPUT
OPTIONAL
AS AN INSERT EFFECT
USING YOUR MIXER’S
SINGLE INSERT JACK
NOTE:
REQUIRES
TRS PLUG
SOURCE AUDIO
CHANNEL 1
AVP MIXER
INPUT
DIRECT OUT
INPUT
MAIN OUTPUT
DOUBLE TRACK
OUTPUT
CHANNEL 2 CHANNEL 3
INPUT
DIRECT OUT
OPTIONAL
INPUT
DIRECT OUT
AS AN
INSERT
EFFECT
USING
TWO
MIXER
CHANNELS
SOURCE AUDIO