Owner`s manual

22
8 PRESET Press this button to display the Select Preset screen.
9SAVE Press this button to save a newly created or edited preset. Also
used to confirm choices in functions that would result in overwriting
current data.
10 Input Level Meter These five LEDs light to indicate the level of the
incoming audio. Ideally, you should adjust the input to the highest level
that does not consistently cause the top red LED to light. (The red LED
lights at a level of -3dB. Digital clipping, which introduces a particularly
nasty-sounding distortion, will occur if the input exceeds 0dB.)
A NOTE ABOUT THE METERS: The AVP’s front panel meters are de-
signed to give you a quick overview of what’s going on with the various
modules. For precise parameter adjustments, appropriate modules
provide high resolution meter displays on their various LCD pages.
The Microphone Modeler Module
11 SOURCE Press this button to select the microphone that was
(or will be) used to record the audio to be processed.
12 MODEL Press this button to select the microphone whose audio
characteristics you wish to apply to your audio.
13 TUBE Press this button to pass your audio through a model of a
high-quality tube preamp with variable tube “warmth.”
14 LOW CUT Press this button to set low cut filters for the source and
model mics and to adjust the mics’ proximity effects.
15 ON When this button is lit, the Mic Modeler module is active. When it is
not lit, the module is bypassed. Pressing the button toggles its state.
The Auto-Tune Module
16 SCALE Press this button to select the scale to be used as target pitches
for correction.
17 SPEED Press this button to set Auto-Tune’s pitch correction speed.
18 Correction Meter This meter indicates, in real time, the amount of pitch
correction being applied to change the input pitch to the target pitch.
The green LEDs indicate that the input is flat and that positive correc-
tion is being applied. Conversely, the yellow LEDs indicate that the
input is sharp and that negative correction is required.
19 ON When this button is lit, the Auto-Tune module is active. When it is
not lit, the module is bypassed. Pressing the button toggles its state.