Owner`s manual

Chapter 2:

Setting Up the Antares Vocal Producer

Setting up the AVP is very straightforward.

1. Find a suitable location. The AVP is designed to be mounted in a

standard 19-inch equipment rack.

2. Connect an audio input to the Line In jack (see Chapter 4 for details of

patching the AVP into your system).

3. Connect a cable to the Main Line Out jack. If you will be using the AVP’s

Stereo Double Tracking feature, connect a second cable to the Double

Track Line Out and route as desired (see Chapter 4 for details of patch-

ing the AVP into your system).

4. If you will be controlling your AVP via MIDI, connect a MIDI cable from

your MIDI source to the AVP’s MIDI IN jack.

5. Confirm that the included power supply is correct for the electricity in

your part of the world. If you are not sure, or the power supply has a

plug that is incompatible with your wall sockets, contact your local

Antares dealer for help.

IMPORTANT! Do not attempt to modify the supply or use any other

supply that is not specifically intended for the AVP.

6. Connect the power supply’s pin connector to the AC INPUT jack on the

rear of the AVP. Then plug the power supply into an AC outlet. Your

AVP will briefly display the version number of its internal firmware and

then display the Select Preset page.